How To Install A Subwoofer In Your Car

Installing a subwoofer in your car or truck can be a great way to enhance the quality of the sound from your onboard system. It can deliver the lower frequencies of music that may be lost by traditional car speaker systems and enable you to hear your music as it was meant to be heard. Additionally, subwoofers expand the sound and provide a more immersive and enjoyable experience.

However, what if your vehicle doesn’t have a subwoofer? Are you interested in learning how to install a subwoofer in a car? You’ve come to the right place. Today, we’ll walk you through what you need to know so that you can decide whether or not this is a do-it-yourself project or a task best handled by professionals.

What You’ll Need For Your Subwoofer Installation

First, you’ll need to purchase the subwoofer you want. There are many shops that specialize in these kinds of sound devices. However, most subwoofers will not come with all the supplies needed for installation. In this case, you may need:

  • Power wire
  • Ground wire
  • RCA wire
  • Blue remote wire
  • Speaker wire
  • 60-amp in-line fuse and fuse holder
  • Wire cutters
  • Wire stripper
  • Electrical tape
  • Panel remover
  • Flashlight
  • Drill
  • Screws
  • And More

The exact amount and type of wire you’ll need will vary depending on the location within the vehicle you are placing the Subwoofer as well as the kind of system you are installing.

A Brief Overview Of The Installation Process

Once you have all your supplies, you’ll want to start by first connecting the wires to the Subwoofer. You’ll need to carefully strip around half an inch of insulation off the ends of the wire using your wire stripper. You can then run the wires into the terminals on the Subwoofer. It’s essential to bear in mind the amount of power usage your subwoofer will need and attach the correct type and amount of wires. Once the subwoofer is prepared for installation, it’s time to head to your vehicle.

At your vehicle, you’ll want to disconnect the battery to prevent any danger of electrocution. You’ll then need to figure out a way to route the power wire from your car’s battery through the firewall (a protective barrier between the car’s cabin and the engine) so that you can power your subwoofer. Then, you’ll need to carefully remove the panel behind which you’re going to install the device. In some vehicles, you can place the subwoofer behind the stereo, while in others, you may place it behind a panel in the trunk of your car. Connecting all the wiring to both the power and the existing sound system of your vehicle can be an extensive and complicated task. It’s essential to be careful not to accidentally do any damage to the vehicle throughout the process.

The Simpler Approach

Like anything in life, there is an easy and a hard way. In this case, the easy way is to simply have the professionals at PDA Road Gear install your subwoofer for you! If you are looking for subwoofer installation in the Denver area, look us up!